Deskripsi Produk Nama Merek: Perfin Model produk: PFJT01 Rated power: 400W Rated voltage: 200V Control method: 3-speed temperature control Rated frequency: 50HZ Ironing function: dry ironing color: White The correct use of steam iron: 1. The yellow and green two-color wires in the power core wire should be grounded before use to prevent the risk of electric shock in case of electricity leakage. 2. Raise the front end so that the water inlet is upward, and the measuring cup will slowly fill the boiling water from the water inlet. The amount of water to be added depends on the volume of the iron reservoir. 3. For an electric iron equipped with a water level glass, the iron can be erected, observe the water level in the water reservoir, and add water as required. 4. The name of the fabric on the steam iron’s fabric sign is basically the same as that of the tempered iron. The difference is an additional “steam” mark. 5. Turn on the iron and turn the temperature control knob to the position between “Wool” and “Linen”. The indicator light should glow. When the light goes out, the soleplate temperature has reached the required value. If water has been added to the iron, steam should “spray” to iron. 6. Dry ironing can be done with a steam iron. The method is to adjust the temperature according to the type of fabric being ironed. Control knob to select the proper base plate temperature. After that, adjust the steam knob to the “0” position. 7. After use, the remaining water in the water reservoir should be poured out from the water supply port. When pouring, the front end of the iron should be downward, and the electric trading bucket should be shaken at the same time. Then turn the temperature knob to the highest temperature range, and power on for a few minutes to evaporate all the internal moisture. Then cut off the power, turn the temperature control knob back to the lowest temperature range, and store it after it has cooled down naturally. Four methods of decontamination in daily use of electric irons: When ironing clothes, due to the high temperature or improper operation, the smooth bottom plate will often be stained with dirt, which affects the effect of ironing clothes. Decontamination method: ① After applying a small amount of toothpaste on the dirt, wipe it vigorously with a clean cotton cloth to remove the dirt; ② The electric iron is preheated to about 100 ° C and cut off the power supply. Wipe the dirt surface several times with a piece of cloth soaked with vinegar, and then wash it with water. ③ The electric iron is preheated to about 100 ° C, cut off the power supply, apply a small amount of baking soda to the dirt, and wipe it back and forth with a clean cloth to remove the dirt; ④ The bottom plate with serious dirt can be polished with cloth dipped in polishing paste to protect the plating layer. |